Computer sleeve with leather strap

Learn how to make your own computer sleeve with this DIY tutorial.

Sleeve til computer i filt med læderstrop - DIY guide

Step 1

Cut the felt to fit the size of your computer. Add an additional two centimeters on each side for stitching.

Sleeve til computer i filt med læderstrop - DIY guide. Step 1

Step 2

Use your space maker to mark out, where your stitching holes will be punctured. Make the markings in one of the ends of the leather strap.

Sleeve til computer i filt med læderstrop - DIY guide. Step 2

Step 3

Cut the other end of the strap into the length, you desire. You can cut off the corners of the strap as a nice detail.

Sleeve til computer i filt med læderstrop - DIY guide. Step 3

Step 4

Use the awl to make stitching holes.

Sleeve til computer i filt med læderstrop - DIY guide. Step 4

Step 5

Tie a knot in one end and start stitching from the back.

Sleeve til computer i filt med læderstrop - DIY guide. Step 5

Step 6

Stitch all the way around. Make sure that there is thread between all the stitching holes - you will have to stick the needle through all the holes twice for this to happen.

Sleeve til computer i filt med læderstrop - DIY guide. Step 6

Step 7

Finish your stitching by tying a knot on the back.

 

Sleeve til computer i filt med læderstrop - DIY guide. Step 7

Step 8

Place your computer into the sleeve to measure out, where the Sam Browne button will be placed. 

Sleeve til computer i filt med læderstrop - DIY guide. Step 8

Step 9

Puncture a hole in the felt for the Sam Browne button and screw in the button.

Sleeve til computer i filt med læderstrop - DIY guide. Step 9

Step 10

Mark out where on your leather, the Sam Browne button will come through from the back. 

Sleeve til computer i filt med læderstrop - DIY guide. Step 10

Step 11

Use your leather punch to punch a hole in the leather. 

Sleeve til computer i filt med læderstrop - DIY guide. Step 11

Step 12

Glue a small piece of leather on the back to ensure that the Sam Browne button doesn't scratch your computer. 

Sleeve til computer i filt med læderstrop - DIY guide. Step 12

Step 13

Sew together the sides inside-out by using a sewing machine.

Sleeve til computer i filt med læderstrop - DIY guide. Step 13

Products for this project

You can buy a package deals with or without tools, or you can buy the products individually. The guide can be downloaded as a PDF file, so that you can print it out.

Leather strap 2.0/2.2 mm thick, 30 mm wide

Felt

Scissors

Punch tong

Sam Browne Button

Glue

Awl

Space maker

Sewing needles, size 1

Terylene, 1 mm, 25 metres per roll

Cutter knife

Ruler

Cork

Hammer

Sewing machine